Zanussi ZBB28441SV User Manual

16 pages

To Next Page

To Next Page

Page #1 background image

Loading...

Page #1 background image

GETTING

STARTED?

EASY.

User Manual

ZBB28441SV

EN User Manual

Fridge Freezer

Table of Contents

Questions and Answers:

D
Danielle ByrdAug 18, 2025
Why is the temperature in my Zanussi ZBB28441SV Freezer too high?
- H
  Heather SandersAug 18, 2025
  If the temperature in your Zanussi freezer is too high, several factors could be responsible. Ensure the temperature regulator is correctly set to a lower temperature. Avoid storing too many food products at once and let warm food cool to room temperature before storing it. Also, regularly defrost the appliance if the frost thickness exceeds 4-5 mm, and ensure proper cold air circulation inside the freezer. Avoid opening the door unnecessarily.
L
Lindsey HowardAug 20, 2025
How to reduce frost and ice buildup in my Zanussi Freezer?
- P
  Pamela SmithAug 20, 2025
  Excessive frost and ice in your Zanussi Freezer can be due to several reasons. Ensure the water drainage plug is correctly positioned. Also, make sure the door closes properly. Avoid setting the appliance to the lowest temperature when it's fully loaded, and adjust to a higher temperature if the ambient temperature is too high. Refer to the "Operation" section for temperature settings.
O
ocarrAug 22, 2025
Why is my Zanussi Freezer not operating?
- R
  Richard NicholsAug 23, 2025
  Your Zanussi Freezer might not be operating due to several reasons: it could be switched off, so try switching it on. The mains plug might not be correctly connected to the mains socket, so ensure it is properly connected. Finally, there might be no voltage in the mains socket, in which case you can test the socket with another electrical appliance or contact a qualified electrician.
L
Lisa AriasAug 26, 2025
Why does the Zanussi Freezer compressor run constantly?
- D
  Doris HenryAug 26, 2025
  Several factors can cause your Zanussi Freezer's compressor to run continually. The temperature setting might be incorrect, or too many food products may have been added at once. High room temperature or placing warm food inside can also contribute. Ensure the door is closed correctly. Allow a few hours after adding food to check the temperature again. Check the climate class chart on the rating plate.
D
Donald HahnAug 28, 2025
What to do if water is flowing inside my Zanussi ZBB28441SV?
- M
  Michelle HopkinsAug 28, 2025
  If you notice water flowing inside your Zanussi Freezer, it could be due to a couple of reasons. First, ensure that food products aren't blocking water from flowing into the water collector by making sure that food products do not touch the rear plate. Also, the water outlet might be clogged, so try cleaning it.
Y
ytorresAug 30, 2025
Why is water flowing on the floor from my Zanussi Freezer?
- R
  Randy PerkinsAug 30, 2025
  If water is flowing on the floor from your Zanussi Freezer, the melting water outlet may not be connected to the evaporative tray above the compressor. Attach the melting water outlet to the evaporative tray.
H
hawkinskaraSep 2, 2025
Why is the temperature in my Zanussi ZBB28441SV too low or too high?
- L
  Lisa HansenSep 2, 2025
  If the temperature in your Zanussi Freezer is too low or too high, it could be due to several factors. The temperature regulator might not be set correctly, so set a higher or lower temperature. The door may not be closed correctly. The food products' temperature might be too high, so let them cool to room temperature before storing. Also, storing many food products at the same time or a frost thickness greater than 4-5 mm can cause this issue, so store less food and defrost the appliance. Opening the door often or a lack of cold air circulation can also affect the temperature, so open the door only when necessary and ensure proper air circulation.
J
john26Sep 4, 2025
What to do if water flows inside my Zanussi Freezer?
- J
  Jon GriffinSep 4, 2025
  If water is flowing inside your Zanussi Freezer, it could be because food products are preventing water from flowing into the water collector. Make sure that food products do not touch the rear plate. Alternatively, the water outlet may be clogged, so try cleaning it.
L
Lisa TorresSep 7, 2025
What to do if water flows on the floor from my Zanussi ZBB28441SV?
- J
  Jamie LeeSep 7, 2025
  If water is flowing on the floor from your Zanussi Freezer, the melting water outlet may not be connected to the evaporative tray above the compressor. Attach the melting water outlet to the evaporative tray.
J
John BlevinsSep 9, 2025
What to do if my Zanussi Freezer does not operate?
- P
  Patricia StevensSep 9, 2025
  If your Zanussi Freezer isn't working, there are a few potential causes. First, make sure the appliance is switched on. Next, check that the mains plug is correctly connected to the mains socket. Finally, ensure there is voltage in the mains socket by testing it with another electrical appliance or contacting a qualified electrician.

Zanussi ZBB28441SV Specifications

General

Appliance placement	Built-in
Product colour	Silver
Door hinge	Right
Reversible doors	Yes
Number of compressors	1
Climate class	SN-N-ST-T
Freezing capacity	4 kg/24h
No Frost system	Yes
Number of freezer drawers	3
Fridge interior light	Yes
Lamp type	LED
Number of fridge shelves	4
Egg balcony	Yes
Bottle rack	Yes
Energy efficiency class	F
Number of Shelves	4
Star rating	4
Width	60 cm
Height	177.2 cm

Related product manuals

Preview: Zanussi ZBB28460SA

Zanussi ZBB28460SA

Preview: Zanussi ZBB28651SV

Zanussi ZBB28651SV

Preview: Zanussi ZBB27450SA

Zanussi ZBB27450SA

Zanussi ZBB24431SV

Preview: Zanussi ZBB27650SV

Zanussi ZBB27650SV

Preview: Zanussi ZBB8294

Zanussi ZBB8294

Zanussi ZBF3124A

Preview: Zanussi ZBF11420SA

Zanussi ZBF11420SA

Preview: Zanussi ZBF22451SA

Zanussi ZBF22451SA

Preview: Zanussi ZBF11421SA

Zanussi ZBF11421SA

Preview: Zanussi ZBT20420SA

Zanussi ZBT20420SA

Preview: Zanussi ZFT610W

Zanussi ZFT610W