How to turn off dEMo mode on Zanussi Freezer?
If you see 'dEMo' on the display of your Zanussi Freezer, it means the appliance is in demonstration mode. To exit this mode, press and hold the OK button for about 10 seconds. You should hear a long sound, and the display will briefly turn off.
Why is there too much frost and ice in my Zanussi ZBB27650SV Freezer?
If you notice too much frost and ice in your Zanussi Freezer, the door might not be closing correctly, or the gasket could be deformed or dirty. Refer to the section on 'Closing the door' to ensure it's sealed properly.
Why is my Zanussi Freezer so noisy?
If your Zanussi Freezer is making unusual noises, ensure it is standing on a stable and even surface.
What to do if my Zanussi ZBB27650SV Freezer does not operate?
If your Zanussi Freezer isn't operating, first ensure the appliance is switched on. Then, check that the mains plug is correctly connected to the mains socket. If the issue persists, test the socket with another electrical appliance to rule out a voltage problem. If there's no voltage, contact a qualified electrician.
Why is the temperature in my Zanussi Freezer too low or too high?
If the temperature in your Zanussi Freezer is too low or too high, start by adjusting the temperature regulator to a more suitable setting. Ensure the door is closing correctly. Allow warm food to cool before placing it inside and avoid storing too much food at once. Limit how often you open the door and check if the "QuickFreeze" or "QuickChill" function is enabled. Finally, make sure there is proper cold air circulation inside the appliance.
What to do if water flows inside my Zanussi ZBB27650SV?
If water is flowing inside your Zanussi Freezer, make sure that food products are not preventing water from flowing into the water collector by touching the rear plate. Also, check if the water outlet is clogged and clean it if necessary.
Why is water flowing on the floor from my Zanussi ZBB27650SV?
If you find water on the floor near your Zanussi Freezer, it's likely that the melting water outlet isn't connected to the evaporative tray above the compressor. Attach the melting water outlet to the evaporative tray.
Why does the compressor operate continually in my Zanussi ZBB27650SV?
If the compressor in your Zanussi Freezer is running constantly, there might be a few reasons. First, check if the temperature is set correctly. If you recently added a lot of food, give it some time to cool down. Also, ensure the room temperature is within the climate class range specified on the rating plate. Make sure food products are cooled before storing them, and that the door is closing properly. Finally, check if the "QuickFreeze" or "QuickChill" function is activated.
Why temperature cannot be set on my Zanussi ZBB27650SV?
If you cannot set the temperature on your Zanussi Freezer, the "QuickFreeze function" or "QuickChill function" might be active. Turn off these functions manually or wait for them to reset automatically before adjusting the temperature.
Why the lamp does not work in my Zanussi ZBB27650SV?
If the lamp in your Zanussi Freezer isn't working, first, close and then open the door to see if it's just in stand-by mode. If it still doesn't light up, the lamp may be defective.
General| Energy Efficiency Class | A+ |
|---|---|
| Total Capacity | 270 L |
| Noise Level | 39 dB |
| Dimensions (H x W x D) | 1770 x 540 x 550 mm |
| Freezing Capacity | 4 kg/24h |
| Number of Shelves | 4 |
| Climate Class | SN-T |
| Weight | 55 kg |
To Next Page