Why is there too much ice in my Zanussi Freezer?
Excessive frost and ice buildup in your Zanussi Freezer may be due to the door not closing correctly or a deformed/dirty gasket. Refer to 'Closing the door' for guidance.
Why is my Zanussi ZBB28651SV making so much noise?
If your Zanussi Freezer is making excessive noise, it might not be properly supported. Check to ensure the appliance stands stable.
What to do if my Zanussi Freezer is not working?
If your Zanussi Freezer isn't operating, first, ensure that the appliance is switched on. Next, check that the mains plug is correctly connected to the mains socket. Finally, verify that there is voltage in the mains socket by connecting a different electrical appliance or contacting a qualified electrician.
Why is the temperature in my Zanussi ZBB28651SV too high?
If the temperature in your Zanussi Freezer is too high, it could be due to several factors: the temperature regulator may not be set correctly (adjust to a lower temperature), the door might not be closed properly (refer to 'Closing the door'), the food products' temperature was too high when stored (cool them to room temperature first), too many food products were stored at once (store less at a time), the door has been opened frequently (open only when necessary), 'QuickFreeze' is on (refer to 'QuickFreeze'), or there's no cold air circulation (ensure proper circulation).
What to do if water flows inside my Zanussi refrigerator?
If water is flowing inside your Zanussi refrigerator, it might be because food products are blocking the water from flowing into the water collector (ensure they don't touch the rear plate) or the water outlet is clogged (clean the water outlet).
What to do if water flows on the floor from my Zanussi ZBB28651SV Freezer?
If water is flowing onto the floor from your Zanussi Freezer, the melting water outlet might not be connected to the evaporative tray above the compressor. Attach the melting water outlet to the evaporative tray.
Why is my Zanussi ZBB28651SV Freezer compressor always running?
The compressor might be running continuously due to several reasons: the temperature may be set incorrectly (refer to 'Operation' for guidance), too many food products were added at once (wait a few hours before checking the temperature again), the room temperature is too high (check the climate class chart on the rating plate), food products placed inside were too warm (allow them to cool first), the door isn't closed properly (refer to 'Closing the door'), or 'QuickFreeze' is enabled (refer to 'QuickFreeze').
Why is my Zanussi ZBB28651SV Freezer lamp not working?
If the lamp in your Zanussi Freezer isn't working, it might be in stand-by mode (try closing and opening the door). If that doesn't work, the lamp may be defective.
Why can't I set the temperature on my Zanussi Freezer?
If you cannot set the temperature on your Zanussi Freezer, it's likely because 'QuickFreeze' is currently enabled. You can either manually switch off 'QuickFreeze' or wait for it to reset automatically. Refer to 'QuickFreeze' for more information.
Why doesn't the Zanussi ZBB28651SV compressor start right away?
If the compressor in your Zanussi Freezer doesn't start immediately after pressing 'QuickFreeze' or changing the temperature, this is normal. The compressor will start after a period of time; no error has occurred.
To Next Page
General