What to do if my Zanussi ZNLN18FS1 does not operate?
If your Zanussi Refrigerator isn't working, there could be a few reasons. First, make sure the appliance is switched on. Next, check that the mains plug is correctly connected to the mains socket. Finally, test the socket by connecting another electrical appliance to see if there is voltage. If not, contact a qualified electrician.
Why is the temperature in my Zanussi Refrigerator too high/too low?
Several factors can cause temperature issues in your Zanussi Refrigerator. Ensure the temperature is set correctly. Allow warm food to cool before storing. Avoid storing too much food at once and only open the door when necessary. If there's excessive frost (over 4-5 mm), defrost the appliance.
How to prevent frost and ice buildup in my Zanussi ZNLN18FS1 Refrigerator?
To minimize frost and ice in your Zanussi Refrigerator, ensure the door closes correctly. Properly wrap food products. For temperature settings, please refer to the "Control Panel" chapter. If the appliance is fully loaded and set to the lowest temperature, set a higher temperature. If the temperature set in the appliance is too low and the ambient temperature is too high, set a higher temperature.
Why is there water flowing inside my Zanussi ZNLN18FS1?
If you notice water inside your Zanussi Refrigerator, it might be because food products are blocking water from flowing into the water collector; ensure food doesn't touch the rear plate. Alternatively, the water outlet could be clogged; try cleaning it.
How to fix the lamp in my Zanussi ZNLN18FS1 Refrigerator?
If the lamp in your Zanussi Refrigerator isn't working, it might be in stand-by mode. Try closing and opening the door. If that doesn't work, the lamp may be defective. In this case, contact the nearest Authorized Service Centre.
Why is water leaking onto the floor from my Zanussi ZNLN18FS1?
If water is leaking onto the floor from your Zanussi Refrigerator, the melting water outlet may not be connected to the evaporative tray above the compressor. Attach the melting water outlet to the evaporative tray.
What to do if the acoustic or visual alarm is on in my Zanussi Refrigerator?
If the acoustic or visual alarm is activated in your Zanussi Refrigerator, it could be due to several reasons. If the cabinet has been recently switched on or the temperature in the appliance is too high, refer to "Door Open Alarm" or "High Temperature Alarm". Another possibility is that the door is left open, so ensure that you close the door.
Why does the compressor in my Zanussi Refrigerator run constantly?
If the compressor in your Zanussi Refrigerator is running continually, check these potential causes: the temperature is set incorrectly (refer to the "Control Panel" chapter), you put many food products in at the same time (wait a few hours and then check the temperature again), the room temperature is too high (refer to the "Installation" chapter), or food products placed inside were too warm (allow food products to cool to room temperature before storing).
Why won't the door of my Zanussi ZNLN18FS1 Refrigerator open easily?
If you're having trouble opening the door of your Zanussi Refrigerator, it might be because you tried to reopen it immediately after closing it. Wait a few seconds between closing and reopening the door.
Why doesn't the compressor start immediately on my Zanussi ZNLN18FS1 Refrigerator?
If the compressor in your Zanussi Refrigerator doesn't start right away after pressing "FastFreeze" or changing the temperature, don't worry. This is normal; the compressor starts after a period of time, so no error has occurred.
Guidelines for safe use by children and individuals with reduced capabilities.
Basic safety rules for the appliance's intended domestic use.
Precautions for safe installation of the appliance by qualified personnel.
Guidelines for safe electrical connection and earthing.
Warnings and advice for safe operation and handling of the appliance.
Refer to safety chapters and specific installation documents for proper setup.
Guide to adjusting the temperature using the regulator and LED indicators.
Instructions for activating and deactivating the rapid freezing function.
Explanation of automatic defrosting and cleaning the drain hole.
Steps and precautions for manually defrosting the freezer compartment.
A guide to diagnosing and resolving typical issues with the appliance.
General| Child lock | No |
|---|---|
| Door hinge | Right |
| Control type | Touch |
| Display type | LED |
| Door assembly | Door slider |
| Product color | White |
| Reversible doors | Yes |
| Shelves material | Glass |
| Appliance placement | Built-in |
| Number of compressors | 1 |
| Country of origin | Italy |
| Freezer position | Bottom-placed |
| Freezing capacity | 4 kg/24h |
| Freezer net capacity | 72 L |
| Freezer gross capacity | 73 L |
| Freezer temperature (min) | -18 °C |
| Freezer number of shelves/baskets | 2 |
| Storage time during power failure | 21 h |
| Noise level | 35 dB |
| Climate class | SN-N |
| Total net capacity | 267 L |
| Total gross capacity | 272 L |
| Minimum operating temperature | -24 °C |
| Cord length | 2.4 m |
| Fridge net capacity | 195 L |
| Fridge gross capacity | 199 L |
| Fridge temperature range | 2 - 8 °C |
| Fridge number of shelves/baskets | 4 |
| Current | 13 A |
| AC input voltage | 230-240 V |
| AC input frequency | 50 Hz |
| Annual energy consumption | 291 kWh |
| Package depth | 600 mm |
| Package width | 590 mm |
| Package height | 1840 mm |
| Package weight | 56000 g |
Weight and Dimensions| Depth | 549 mm |
|---|---|
| Width | 548 mm |
| Height | 1772 mm |
| Weight | 54000 g |
To Next Page
