EasyManuals Logo

Zanussi ZR 171 UN User Manual

Zanussi ZR 171 UN
12 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #8 background imageLoading...
Page #8 background image
19
Check the position again by slackening the screws
and pins then, once the best position has been
obtained, fully tighten all the fixings.
Cover the visible part of the top bracket on the panel
with plastic cover (D), inserting it in the locations
provided in the bracket.
Once the door has been correctly aligned, tighten the
holding nuts on the fixing brackets and attach the
appliance to the adjacent units and the bottom of the
work surface (Fig. 11).
If the appliance has been fitted into a space 820 mm
high and the maximum height of the base plate is 100
mm, fit the front cover plate by pushing the two
vertical lugs into the rectangular holes on the bottom
side of the ventilation duct until they click. The plate
can be adjusted backwards or forwards in the holes
(Fig. 12).
If the base plate is between 100 and 135 mm high, cut
it as shown in Fig. 14 and mount as described above.
If the base plate is between 135 and 170 mm high, cut
it as shown in Fig. 12.
Fig. 10
Fig. 11
Fig. 12
Fig. 13
D472
D
D517
135
185
170
220
600
820
870
D518
100
150
820
870
20÷80
D546
min.
50cm
2

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Zanussi ZR 171 UN and is the answer not in the manual?

Zanussi ZR 171 UN Specifications

General IconGeneral
BrandZanussi
ModelZR 171 UN
CategoryRefrigerator
LanguageEnglish

Related product manuals