Why Zanussi Refrigerator is not working?
Your Zanussi Refrigerator might not be working due to several reasons: * The appliance is switched off, so switch it on. * The mains plug is not correctly connected to the mains socket, so connect it correctly. * There is no voltage in the mains socket. Connect a different electrical appliance to the mains socket or contact a qualified electrician.
What to do if water flows inside Zanussi ZRAN88FS?
If water is flowing inside your Zanussi refrigerator: * Make sure that food products do not touch the rear plate, as they may prevent the water from flowing into the water collector. * Clean the water outlet, as it may be clogged.
What to do if water flows on the floor from Zanussi ZRAN88FS Refrigerator?
If water is flowing on the floor from your Zanussi refrigerator, attach the melting water outlet to the evaporative tray, as it is not connected to the evaporative tray above the compressor.
How to fix too much frost and ice in Zanussi Refrigerator?
If there is too much frost and ice in your Zanussi refrigerator, it could be because: * The door is not closed correctly. Please refer to \"Closing the door\" section. * The gasket is deformed or dirty. Please refer to \"Closing the door\" section.
How to fix a noisy Zanussi ZRAN88FS Refrigerator?
If your Zanussi refrigerator is noisy, check if the appliance stands stable, because the appliance is not supported properly.
What to do if the lamp does not work in Zanussi ZRAN88FS?
If the lamp in your Zanussi refrigerator does not work: * Close and open the door, as the lamp may be in stand-by mode. * Refer to \"Replacing the lamp\" section, as the lamp may be defective.
What to do if the temperature in Zanussi Refrigerator is too high?
If the temperature in your Zanussi refrigerator is too high, it could be due to several reasons: * The temperature is not set correctly. Set a lower temperature. * The door is not closed correctly. Please, refer to \"Closing the door\" section. * The food products' temperature is too high. Let the food products temperature decrease to room temperature before storage. * Many food products are stored at the same time. Store less food products at the same time. * The thickness of the frost is greater than 4-5 mm. Defrost the appliance. * The door has been opened often. Open the door only if necessary.
Why is there too much condensed water on the rear wall of my Zanussi ZRAN88FS Refrigerator?
Too much condensed water on the rear wall of your Zanussi refrigerator can be caused by: * Opening the door too frequently. Open the door only when necessary. * The door not being closed completely. Make sure the door is closed completely. * Storing unwrapped food. Wrap food in suitable packaging before storing it in the appliance.
Why Zanussi ZRAN88FS compressor operates continually?
The compressor in your Zanussi refrigerator might be running continually because: * The temperature is set incorrectly. Refer to \"Control Panel\" chapter. * Many food products were put in at the same time. Wait a few hours and then check the temperature again. * The room temperature is too high. Refer to \"Installation\" chapter. * Food products placed in the appliance were too warm. Allow food products to cool to room temperature before storing. * The door is not closed correctly. Refer to \"Closing the door\" section.
Why Zanussi ZRAN88FS Refrigerator door does not open easily?
If your Zanussi Refrigerator door does not open easily, wait a few seconds between closing and re-opening of the door, because you attempted to re-open the door immediately after closing.
General| Brand | Zanussi |
|---|---|
| Model | ZRAN88FS |
| Category | Refrigerator |
| Language | English |
To Next Page