What to do if I cannot open the Zanussi ZWF144A2PW door?
To resolve this, be sure that a washing programme that ends with water in the tub has not been selected. Also, make sure the washing programme is finished. If there's water in the drum, set the drain or spin programme. Ensure the appliance is receiving electrical power.
Why Zanussi ZWF144A2PW Washer spin phase does not operate?
First, set the spin programme. If the issue persists, manually adjust the items in the tub and start the spin phase again, as this problem may be caused by balance problems.
How to fix Zanussi ZWF144A2PW Washer not filling with water properly?
Ensure the water tap is fully open. Also, check that the water supply pressure isn't too low by contacting your local water authority. Another thing to check is that the water tap isn't clogged. Inspect the inlet hose for any kinks, damages, or bends, and verify that it's correctly connected. Finally, make sure that the filter of the inlet hose and the filter of the valve are not clogged. Refer to 'Care and cleaning'.
Why Zanussi Washer program does not start?
First, verify that the mains plug is correctly connected to the socket. Then, ensure that the appliance door is fully closed. Check the fuse box for any damaged fuses. Make sure you've touched the Start/Pause button. If the delay start is active, either cancel it or wait for the countdown to finish. Also, deactivate the Child Lock if it's enabled. Finally, check that the knob is correctly positioned on the selected program.
What to do if there is water on the floor near Zanussi ZWF144A2PW Washer?
Make sure that the couplings of the water hoses are tight and there are not water leakages. Check the water inlet and drain hoses for any damages. Ensure you're using the correct detergent in the correct quantity.
How to stop Zanussi Washer from making unusual noise?
Ensure the appliance is correctly leveled. Also, verify that the packaging and/or transit bolts have been removed. If the load is too small, add more laundry to the drum.
What to do if the mains supply is unstable for Zanussi ZWF144A2PW?
Wait until the mains supply is stable.
What to do for internal fail of Zanussi ZWF144A2PW Washer?
To solve this, switch the appliance off and on again.
Why Zanussi ZWF144A2PW Washer fills with water and drains immediately?
Make sure that the drain hose is in the correct position, as it may be positioned too low. Refer to 'Installation instruction'.
Why Zanussi ZWF144A2PW Washer programme duration changes?
The AutoAdjust System adjusts the programme duration based on the type and size of the laundry load. Refer to 'The AutoAdjust System load detection' in 'Daily Use' chapter.
To Next Page
General
