AEXZP0BB - ECO SMART DISPLAY - User Manual Page - 27/43
Flow chart showing how to make Program changes using Digital Console:
1) Opening Zapi Menu
DISP E ZP V0.0
48V 0A 00000
2) Press ENTER to go into the MAIN MENU
' % '
' ' '
3) The Display will show: PARAMETER CHANGE
MAIN MENU
PARAMETER CHANGE
4) Press ENTER to go into the Parameter
Change facility
' % '
' ' '
5) The Display will show the first parameter
CHECK UP TYPE
LEVEL = 1
6) Press either ROLL UP and ROLL DOWN to
display the desired parameter
% ' '
% ' '
7) The names of the desired parameter appears
on the Display
CHECK UP HOURS
100
8) Press either SET UP or SET DOWN buttons to
change the value
' ' %
' ' %
9) The Display will show the new value
CHECK UP HOURS
400
10) When you are satisfied with the results of the
changes you have made, press OUT
' ' '
' % '
11) The Display asks “ARE YOU SURE?”
ARE YOU SURE?
YES=ENTER NO=OUT
12) Press ENTER to accept the changes, or press
OUT if you do not accept the changes
' % '
' ' '
' ' '
' % '
15) The Display will show: PARAMETER CHANGE
MAIN MENU
PARAMETER CHANGE
To Next Page
Loading...
General