ZappBug Oven 2 - Thermometer Base Station Configuration

©2014-2019 ZappBug. All rights reserved. Product specications subject to change. 12
Thermometer Base Station Set Up
3
1
2
1. Time
2. Ambient Room Temperature
3. Reception Icon
4. Probe Sensor Temperature
1. Battery Compartment
2. Stand Mount
2
1
Figure 2
Figure 2
Figure 1
Figure 1
1. Remove the battery door on the back of the base station as, shown in
Figure 1 below.
2. Insert one AA battery. All of the LCD segments will light up for a few seconds
to verify that all segments are operating properly.
3. The thermometer base station will instantly display the ambient temperature.
The probe temperatures will update on the display within a few minutes after
you place batteries in the thermometer probe. See Thermometer Probe Set
Up on page 13.
4
Use & Operation (continued)
IMPORTANT: Insert batteries and set
up thermometer base station rst