EasyManua.ls Logo

Zareba SP10 - Fence Controller Installation; Charge Battery

Default Icon
40 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
- 4 -
Fence Controller Installation
• Battery is pre-installed in all models. With fence controller in OFF
position, allow the sun to fully charge the battery for three days to
ensure optimal battery life.
STEP 1: Charge Battery
NOTE: Make sure switch is
in the OFF (0) position.
Models SP3/LIS3/SP10/LIS10
Model SP30
Solar Battery Maintenance
• Low battery can be recharged by removing battery and using 6-volt
charger (part no. SBC1).
• When not in use, fully charge battery before storage.
WARNING: Do not charge battery with an automobile battery
charger as this will damage battery.
The normal life of the internal battery is typically three to four years
provided it is properly maintained. A solar fence controller that is being
stored should be placed in the sun for three days every three months
to recharge the battery. Any fence controller in use that doesn’t receive
sunlight for a period of two weeks should be recharged for three days
in sunlight with the fence controller turned OFF.

Related product manuals