Step 1
Step 2
Tie any simple knot such as a square
knot. Strip back and cut poly strands
leaving two inches of conductive
wires exposed. Twist or “pigtail”
wires together.
Stagger ends of poly rope
and tightly secure using
poly rope splicer.
Poly Wire
Metal Wire
Never use loose or
single-wrap splices
Make one-foot loop. Insert poly tape
through center of
buckle and slip
closed end over the
upright flange.
Pull poly tape tight
and over flange.
Step 1
Step 3
Step 2
Poly Tape (using part no. SBS4 or SBL4)
Poly Rope (using part no. PRS2)
To Next Page
Loading...
