Zebra 3 FM

8
A. TX Antenna (#58005)
B. Neck strap (#58311)
C. Trainer cord (#58318)
D. Switch harness (#57215S)
E. Heavy duty gold pin switch harness (#54407) This can be removed
F. Stick extensions (#56381)
G. Flight Preserver (#58480)
4. REPLACEMENT PARTS & ACCESSORIES
Congratulations again and have fun!
Austria, Belgium, Denmark, Finland,
France, Germany, Greece, Iceland,
Ireland, The Netherland, Italy, Spain,
Norway, Portugal, United Kingdom,
Luxembourg, Sweden, Switzerland
MADE IN THE PHILIPPINES
Zebra 3 FM Instruction Manual
The following is a listing of replacement parts and
accessories available for the Zebra radio series from your hobby dealer.
- Always turn your transmitter on first and off last.
- Never operate your system without first performing a proper range check.
- FCC regulation in the USA prohibits changing the crystal in your transmitter.
For channel changes send your system to an authorized service/repair center.
- Never fly around or over houses, people or power lines.
- Always charge your batteries before you fly.
- It's a good idea to check your receiver batteries with a tester
This will verify the charge level in your receiver batteries.
- Always fly responsibly and respect the rights of others.
- Make sure your frequency is clear before turning on your system.
5. PRECAUTIONS
Instruction Manual

Zebra 3 FM Specifications

General

Brand	Zebra
Model	3 FM
Category	Remote Control
Language	English

Summary

Transmitter

Transmitter Layout

Diagrams illustrating the front and back layout of the Zebra 3 FM transmitter, identifying key controls and components.

Servo Reversing

Explains how to change the travel direction of servos using reversing shunt switches on the transmitter.

Mixing Function (Aero Version)

Details on using the mixing switch for Aero transmitters to combine CH1 and CH2 for specific aircraft types.

Trim Levers Operation

Instructions on using trim levers for fine-tuning control surface positions and linkage adjustments.

LED Battery Indicator

How to interpret the LED indicator for transmitter battery status and guidance on when to cease operation.

Battery Installation

Operation

Receiver and Servo Installation

Steps for connecting the receiver and servos to the transmitter, and initial checks for proper movement.

System Settings and Checks

Procedures for checking servo operation, connections, and servo direction using reversing switches.

Simulator System Compatibility

Information on the compatibility of the Zebra 3FM system with simulator interface cords and FMS flight simulator.

Range Checking Procedure

Essential steps for performing a range check before each operation to ensure control at a safe distance.