Zebra II User Manual

ZebraNet Connect for Windows
®
Windows NT 4.0/Windows 2000
If you are using the Windows NT 4.0 or Windows 2000 operating system, use the following
procedure to setup a printer port for the PrintServer II.
1. Select Start, Settings and then Printers.
2. Select the Windows printer to use when printing with the PrintServer II Connect.
3. Select Properties from the File menu.
4. To add an PrintServer II Connect port, select Add Port under the Ports tab.
5. From the list of Available Printer Ports, select ZebraNet Connect Monitor as the
type of port to add and click New Port.
NOTE: If PrintServer II Connect is not listed, verify the ZebraNet Connect
software has been properly installed.
You will enter into the Add ZebraNet Connect Port screen where there will be a list
of all PrintServer II print servers available on the local subnet.
• The TCP/IP monitor will search only the local subnet.
• The IPX/SPX monitor will retrieve all devices found in the NetWare bindery.
6. If the port you wish to add is listed in the Ports available on local subnet: window,
select the port name. If the port you wish to use is not listed, you may:
• Select Cancel and repeat step 5 to rediscover the print servers.
•
In ZebraNet Connect for IPX/SPX, click Search and enter the print server’s
Network Number and Hardware Address.
•
In ZebraNet Connect for TCP/IP, click the Locate non-local device button and enter
the Static TCP/IP Address used for the print server.
NOTE: The ZebraNet Connect for TCP/IP DHCP discovery feature will
relocate a print server on the local subnet by its port name, even if the IP
address changes. This feature is enabled on the local subnet only. A
non-local print server will not be re-discovered if the IP address changes.
7. Click Add.
8. Click Cancel to close the Printer Ports dialog.
9. Click OK to save the configuration.
You will now be able to use ZebraNet Connect. Whenever you print to the Windows printer
configured with ZebraNet Connect, your print job will go directly to the ZebraNet print
server port.
ZebraNet™ PrintServer II Installation and Operation Guide 11

Zebra II Specifications

General

Model	Zebra II
Category	Print Server
Connectivity Technology	Ethernet
Data Link Protocol	Ethernet
Network / Transport Protocol	TCP/IP
Management Protocol	SNMP
Operating System Compatibility	Linux, Unix