Zebra TC75x User Manual

Quick Start Guide 5
3. Ensure that the SAM card is seated properly.
Installing a microSD Card
The microSD card slot provides secondary non-volatile storage. The slot is located under the battery pack. Refer to the
documentation provided with the card for more information, and follow the manufacturer’s recommendations for use.
1. Remove the hand strap, if installed.
2. Lift the access door.
3. Insert the microSD card into the card holder door ensuring that the card slides into the holding tabs on each side of the door.
4. Re-install the access door.
Installing the Hand Strap and Battery
1. Remove the hand strap filler from the hand strap slot. Store the hand strap filler in a safe place for future replacement.
CAUTION Follow proper electrostatic discharge (ESD) precautions to avoid damaging the microSD card. Proper ESD precautions
include, but are not limited to, working on an ESD mat and ensuring that the operator is properly grounded.
NOTE Installation of the hand strap is optional. Skip this section if not installing the hand strap.

Zebra TC75x Specifications

General

Brand	Zebra
Model	TC75x
Category	Desktop
Language	English