110
Troubleshooting
Advanced Mode
1/13/2016 ZD420 User’s Guide 212485-001 Rev. A
Manual Print Width Adjustment
While in Advanced Mode, pressing MEDIA indicator () while the Pause indicator () is
illuminated yellow will start Manual Print Width Adjustment while in Advanced mode, see
Advanced Mode on page 109. The printer will print a 16mm (0.63 inch) box and pause
momentarily. The printer will then print a slightly larger box and again pause. When you see the
printer print a box that matches the width of your media, press FEED to set the print width and
return to READY state.
To return to the maximum print width setting, allow the printer to proceed without pressing the
FEED button.
To Next Page
Loading...
