116
Maintenance
Cleaning
1/13/2016 ZD420 User’s Guide 212485-001 Rev. A
3. Rub the cleaning pen across the dark area of the printhead. Clean from the middle to the
outside. This will move adhesive transferred from the outer edges of media to the area
outside of media path.
4. Wait one minute before closing the printer.
5. Release the Printhead Actuator Arm and then push the Ribbon Drive Transport into the
Printhead Actuator Arm. The Release Arms will snap into place relinking the Ribbon Drive
Transport to the top cover and the Printhead Actuator Arm.
To Next Page
Loading...
