120
Maintenance
Cleaning
1/13/2016 ZD420 User’s Guide 212485-001 Rev. A
Cleaning the Cutter and Label Dispenser Options
This is a continuation of cleaning the media path for either option if it is installed on your printer.
Cutter
The media path surfaces can be cleaned but not the internal cutter blades or mechanism.
1. Wipe the ridges and the plastic surfaces of the media entry (inside) and exit slot (outside) of
the cutter. Clean inside the areas outlined in blue.
2. Repeat as necessary to remove any adhesive or contaminate residue after it dries.
Label Dispenser
1. Open the door and clean the peel bar, inner surfaces and ridges on the door.
2. Wipe the roller while rotating it. Discard the swab or cloth and clean again to remove residue.
3. Clean the sensor window. The window should be clear of streaks and residue.
Ridges
Pinch Roller
Peel Bar
Label Taken Sensor
To Next Page
Loading...
