148
Appendix: ZPL Configuration
Configuration Setting to Command Cross-reference
1/13/2016 ZD420 User’s Guide 212485-001 Rev. A
The configuration settings listed here resume after the TAKE LABEL sensor value. These
listings contain printer features seldom changed from default or provide status information
(e.g. Firmware Version).
Table 2 • ZPL Commands and Configuration Receipt Callout Cross-Reference
The printer has the ability to set a command or a group of commands once for all receipts (or
labels) that follow. Those settings will remain in effect until they are changed by subsequent
commands, the printer is reset, or you restore factory defaults.
Command Listing Name Description
^MP
MODES ENABLED Default: CWF (See ^MP Command)
MODES DISABLED Default: (nothing set)
^JM
RESOLUTION Default: 448 8/mm FULL (203 dpi)
640 8/mm FULL (300 dpi)
—
FIRMWARE Lists ZPL Firmware Version
—
XML SCHEMA 1.3
—
HARDWARE ID Lists Firmware Boot-block Version
LINK-OS VERSION
—
CONFIGURATION CUSTOMIZED (after first use)
—
RAM 2104k........ R:
—
ONBOARD FLASH 6144k.........E:
^MU
FORMAT CONVERT NONE
RTC DATE Date Displayed
RTC TIME Time Displayed
^JI / ~JI
ZBI DISABLED (Requires key to enable)
—
ZBI VERSION 2.1 (Displayed if installed)
—
ZBI STATUS READY
^JH
^MA
~RO
LAST CLEANED X,XXX IN
HEAD USAGE X,XXX IN
TOTAL USAGE X,XXX IN
RESET CNTR1 X,XXX IN
RESET CNTR2 X,XXX IN
NONRESET CNTR0 (1, 2) X,XXX IN
RESET CNTR1 X,XXX IN
RESET CNTR2 X,XXX IN
SLOT1 EMPTY / SERIAL / WIRED
MASS STORAGE COUNT 0
HID COUNT 0
USB HOST LOCK OUT OFF /ON
—
SERIAL NUMBER XXXXXXXXXXX
^JH
EARLY WARNING MAINT. OFF
To Next Page
Loading...
