38
Setup
Loading Roll Media
1/13/2016 ZD420 User’s Guide 212485-001 Rev. A
Loading Roll Media (continued)
6. Cutter Models - For printers with the optional cutter module installed, thread the media through
cutter’s media slot and pull it out the front of the printer.
7. Close the printer. Press down until the cover snaps closed.
You may need a calibrate your printer for the media. The printer’s sensors need to adjust to
sense the label, the liner, and the distance between labels to operate properly. When reloading
the same media (size, vendor, and batch), you can just press the Feed (Advance) button once to
prepare the media for printing.
To Next Page
Loading...
