59
Setup for Windows OS
Configure Using the Connectivity Wizard
1/13/2016 ZD420 User’s Guide 212485-001 Rev. A
15. Determine if you will send the script immediately, or save it for use at a later time.
16. Observe the wireless status on the printer’s indicator lights, and confirm that you have set up your
printer for wireless connectivity.
To... Then...
Complete setup by
sending the ZPL script to
the printer through the
port selected at the
beginning of this
procedure
a. Verify that the printer is connected to the
computer through the port you selected.
Note • For serial connections, use a serial null
modem cable.
b. If you have not already done so, turn ON the
printer.
c. On the Review and Send ZPL for Wireless
window, click Finish.
The printer sends the ZPL script to the printer
through the selected port. The Wireless Setup
Wizard screen closes.
d. Turn the printer OFF and then back ON.
Save the ZPL script to a
file for use later or for
use with other printers
Note • You can send the ZPL script file to
multiple printers that use the same
configuration, or you can send the file to a
printer that had the network settings restored to
the factory defaults. This saves you from having
to go through the Wireless Setup Wizard more
than once.
a. On the ‘Review and Send ZPL for Wireless’
window, highlight the script, right-click, and select
Copy.
b. Open a text editor, such as Notepad, and paste
the script into the application.
c. Save the script.
d. In the Connectivity Wizard, click Cancel to exit
without sending the script at this time.
e. If you have not already done so, turn ON the
printer.
f. Send the ZPL file to the printer through the
connection of your choice.
To Next Page
Loading...
