Zebra ZD500 series User Manual

vi
P1062653-002 Rev. A ZD500 Series™ Thermal Transfer PrinterUser’s Guide 1/16/2014
NCC
經型式認證合格之低功率射頻電機，非經許可，公司、商號或使用者均不得擅自變
更頻率、加大功率或變更原設計之特性及功能。低功率射頻電機之使用不得影響飛
航安全及干擾合法通信；經發現有干擾現象時，應立即停用，並改善至無干擾時方
得繼續使用。前項合法通信，指依電信法規定作業之無線電通信。低功率射頻電機
須忍受合法通信或工業、科學及醫療用電波輻射性電機設備之干擾。
According to "Administrative Regulations on Low Power Radio Waves Radiated Devices"
Without permission granted by the NCC, any company, enterprise, or user is not allowed to
change frequency, enhance transmitting power or alter original characteristic as well as
performance to an approved low power radio-frequency devices. The low power radio-
frequency devices shall not influence aircraft security and interfere legal communications; If
found, the user shall cease operating immediately until no interference is achieved. The said
legal communications means radio communications is operated in compliance with the
Telecommunications Act.
The low power radio-frequency devices must be susceptible with the interference from legal
communications or ISM radio wave radiated devices.

Zebra ZD500 series Specifications

General

Print Method	Thermal Transfer and Direct Thermal
Resolution	203 dpi (8 dots/mm)
Max Print Width	4.09" (104 mm)
Max Print Length	39" (991 mm)
Media Sensors	Reflective and Transmissive
Media Length	39 in./991 mm
Storage Temperature	-40°F to 140°F (-40°C to 60°C)
Operating Humidity	20% to 85% (non-condensing)
Storage Humidity	5% to 95% (non-condensing)
Connectivity	Ethernet, Serial, Bluetooth
Memory	128 MB Flash
Programming Languages	ZPL