Zebra ZD500 series - Page 81

69
Printer Configuration
Changing Printer Settings
1/16/2014 ZD500 Series™ Thermal Transfer Printer User’s Guide P1062653-002 Rev. A
LANGUAGE Menu
Table 11 • LANGUAGE Menu
Language If necessary, change the language that the printer displays.
This change affects the words shown on the following:
• the Home menu
• the user menus
• error messages
• the printer configuration label, the network configuration label, and other labels that you
can select to print through the user menus.
Note • The selections for this parameter are displayed in the actual languages to
make it easier for you to find one that you are able to read.
Accepted values:
See the ZPL programmer’s guide - ZPL and SGD enter
the values differently.
Related ZPL command(s): ^KL
SGD command used: display.language
Printer web page:
View and Modify Printer Settings > General Setup >
Language
ZPL
Override
Enable ZPL Override
Enable this menu item to prevent the following ZPL commands from changing the printer’s
current settings:
• ^MM (print mode)
• ^MT (Direct Thermal or Thermal Transfer print method)
• ^MN (media type non-continuous or continuous)
When this menu item is disabled, these commands override the printer’s settings.
Accepted values:
• DISABLED
• ENABLED
Related ZPL command(s):
none
SGD command used:
zpl.zpl_override
Printer web page:
N/A