20
ZQ300 Series User Guide
5-Bay Docking Cradle
Use Case: Settlement Room
The ZQ300 Series 5-Bay Docking Cradle is designed to dock
and charge up to ve (5) ZQ310 and ZQ320 printers simultane-
ously. The 5-bay cradle is benecial for use in settlement rooms
where space and electrical outlets are at a premium and charg-
ing in volume is critical. The 5-bay cradle charges the printer from
empty to full in less than four (4) hours. The user is allowed to op-
erate the printer during charging, although the media compart-
ment is not accessible while the printer is docked.
1. Ensure that the 5-bay cradle has been installed properly per
its instruction manual. Ensure that the power supply is prop-
erly connected and its power indicator LED is on (see be-
low).
2. Slide a printer into any one of the ve docking bays as
shown in Figure 9.
Note • If you are using a shoulder strap, ensure it is pulled away
from the printer when docking on the cradle.
LED
Figure 9 • 5-Bay Docking Cradle
To Next Page
Loading...