Zebra ZQ320 - Keep-Out Areas for Label Design

29
ZQ300 Series User Guide
Keep-Out Areas
At times, incomplete printing of text and/or graphics appear be-
cause minimum margins are not provided during label design.
The recommended minimum margins, or “keep out areas” are
shown in Figure 18.
Note • The length of each “continuous” receipt is determined by the data
sent to the printer.
Figure 18 • Keep Out Areas
0.59 in.
(15 mm)
* *
*
*
*
*
Receipt Paper with Black Bars
* Maintain a minimum “keep out area” of
1/16 in. (1.59 mm) from the two outer edges
of the paper roll and from the black bars.
Continuous Receipt Paper
(without Black Bars)
* Maintain a minimum “keep out area” of
1/16 in. (1.59 mm) from the two outer edges
of the paper roll.