35
ZQ300 Series User Guide
• 2 bars >= 33% SoC
• 1 bar >/= 15% SoC
The rst LED bar on the left will blink when the battery is at
less than15% SoC.
All LED’s will blink twice per second when printer is powered
on with no battery installed.
Fault LED Behavior
The Fault icon is backlit by a single Amber LED. If there is no
fault present, the LED will be turned off. An Out of Media condi-
tion is represented by the LED on solid as shown below.
In the presence of a Media Cover Open fault, the LED will
blink one time per second. If both an Out of Media and Media
Cover Open condition are present, the cover open state will take
precedence the blinking LED will be displayed.
When a Head Element Out and Head Over Temp condition is
present, the fault LED will blink once every two seconds. This
condition will take precedence over other conditions.
To Next Page
Loading...