14
ZQ500 Series User Guide
Getting Ready to Print
Battery
Installing the Battery
Important • Batteries are shipped in sleep mode to preserve their
maximum capacity while in storage prior to initial use. Plug the
battery into the Smart Charger 2 or Quad Charger (see Pg. 17) to wake
it up before using for the first time.
1. Locate the battery compartment on the bottom of the
printer.
2. Insert the battery into the printer as shown in Figure 1. (It
is not possible to insert the pack in an incorrect orienta-
tion.)
3. Rock the battery into the compartment as shown until it
locks in place.
When the battery is first installed, the control panel indica-
tors may briefly turn on and then go off which indicates the
battery is not fully charged.
Figure 1: Installing the Battery (ZQ510 Shown)
To Next Page
Loading...