17
ZQ500 Series User Guide
Figure 2: Smart Charger-2 (SC2)
Height Width Length
65.1 mm (2.56 in.) 101.5 mm (4 in.) 120.9 mm (4.75 in.)
SC2 Dimensions
Charge Status Icon Health Status Icon
Model UCLI72-4 Quad Charger (AC18177-5)
The UCLI72-4 Quad Charger is designed to charge up to four (4)
ZQ500 Series battery packs simultaneously. Batteries must be re-
moved from the printer to be charged in the Quad Charger.
1. Ensure that the charger has been installed properly per the
Quad Charger instruction manual. Ensure that the power indi-
cator on the front panel is on.
2. Plug a battery pack into any one of the four charging bays as
shown in Figure 5, noting the orientation of the battery pack.
Slide the battery pack into the charging bay until it stops and
then rock the battery pack back until it snaps into place. The
amber indicator directly under the battery being charged will
turn on if the battery is properly inserted.
Smart Battery
Charge Status
LED Indicator
Health Status
LED Indicator
To Next Page
Loading...