Zebra ZT400 Series - Page 39

1019 I H- 5120VN D
39
Printer Setup and Operation
Load the Media—Tear-Off Mode
4. Close the media door.
5. Set the printer to Tear-Off mode (for more information, see Print Mode on page 105).
6. Press PAUSE to exit pause mode and enable printing.
The printer may perform a label calibration or feed a label, depending on your settings.
7. For best results, calibrate the printer. See Calibrate the Ribbon and Media Sensors
on page 144.
8. If desired, perform the CANCEL Self Test on page 190 to verify that your printer is able to
print.
Media loading in Tear-Off mode is complete.