1019 I H- 5120VN D
Printer Setup and Operation
Load the Media—Peel-Off Mode (with our without Liner Take-Up)
48
9. Does the media that you are using require ribbon for printing? If you are not sure, see
When to Use Ribbon on page 23.
10. Close the media door.
11. Set the printer to Peel-Off mode (for more information, see Print Mode on page 105).
12. Press PAUSE to exit pause mode and enable printing.
The printer may perform a label calibration or feed a label, depending on your settings.
13. For best results, calibrate the printer. See Calibrate the Ribbon and Media Sensors
on page 144.
14. If desired, perform the CANCEL Self Test on page 190 to verify that your printer is able to
print.
Media loading in Peel-Off mode is complete.
If using… Then…
Direct Thermal media (no ribbon needed) Continue with step 10.
Thermal Transfer media (ribbon needed)
a. If you have not already done so,
load ribbon in the printer. See
Load the Ribbon on page 58.
b. Continue with step 10.
To Next Page
Loading...