1019 I H- 5120VN D
Printer Setup and Operation
Load the Media—Rewind Mode
54
14. Close the media door.
15. Set the printer to Rewind mode (for more information, see Print Mode on page 105).
16. Press PAUSE to exit pause mode and enable printing.
The printer may perform a label calibration or feed a label, depending on your settings.
17. For best results, calibrate the printer. See Calibrate the Ribbon and Media Sensors
on page 144.
18. If desired, perform the CANCEL Self Test on page 190 to verify that your printer is able to
print.
Media loading in Cutter mode is complete.
To Next Page
Loading...