EasyManua.ls Logo

Zeegma Ironee - Steam Ejection Function; Anti Calc System; Anti Drip System; Cordless Ironing

Zeegma Ironee
70 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EN
5. Set the steam control knob to the desired posion, adjusng the amount
of steam according to the type of fabric.
Note! Steam ironing is only possible at higher temperature sengs. Other-
wise, water may leak from the machine.
STEAM EJECTION FUNCTION
1. Place the device in a horizontal posion. Fill the water tank (see: Filling
the water tank). Place the device in a vercal posion.
2. Set the temperature control knob to the “MAX” posion.
3. Wait unl the iron plate heats up and the light indicator turns blue.
4.
Press the steam ejecon buon (B, g. A). Pressing the buon several
mes beforehand may be necessary to prepare the machine for operaon.
5.
Wait a few seconds for the steam to penetrate the fabric before pressing
the buon again. For maximum eciency, it is recommended not to use this
funcon more than three mes in a row aer the light indicator turns blue.
The steam ejecon funcon is parcularly helpful in removing stubborn
creases. It can be used for both steam and dry ironing.
ANTI CALC SYSTEM
An Calc is a system located inside the water tank that eliminates im-
puries from the water and reduces the problems of scale accumulaon.
To prolong the eecveness of this system, perform the following steps
periodically:
1. Unplug the iron from the power supply and let it cool down.
2. Fill the water rell container to about ¾ of its capacity. Add 1 teaspoon
of salt to the water and ll the water tank with the prepared soluon.
3.
Leave the soluon in the water tank for 15 minutes, shaking it gently from
me to me, and then pour out the soluon.
4. Fill the water tank a second me with the salt water soluon, shaking it
occasionally, and empty it again aer 15 minutes.
5. Fill the tank with fresh water to rinse it, and then pour out the water.
ANTI DRIP SYSTEM
An Drip is a system that constantly controls the ow of water to the iron
plate. Below a certain temperature, the an drip funcon interrupts the
water ow and prevents water from dripping onto the fabric.
CORDLESS IRONING
To use the device in the cordless version, press the wireless base buon (L,
Figure A), and then remove the device from the base.