Zeegma Ironee - Post-Use Procedures; Self-Cleaning Function; Cleaning and Maintenance

EN
STEPS TO FOLLOW AFTER EACH USE
1. Turn o the iron and unplug it from the power source.
2. Wait for the iron to cool down before storing it. Empty the iron. Do not
store the iron with water inside.
3. Always store the iron vercally to protect the iron plate from scratches,
corrosion or stains.
4. For cordless use: always place the iron on the stand to protect the iron
plate from scratches, corrosion or stains. Proper placement of the iron
on the stand will signal a click.
SELF-CLEANING FUNCTION
It is recommended to use the self-cleaning funcon on average once a
month or more oen, depending on the frequency of use. To use the func-
on:
1. Fill the water tank halfway.
2. Set the iron on the base.
3. Set the temperature control knob to MAX.
4. Connect the iron to a power source.
5. Allow the iron to heat up unl the indicator light turns blue.
6. Disconnect the iron from the power source.
7. Hold the iron horizontally over the sink.
8. Set the steam control knob to the “Self clean” posion. Boiling water and
steam will now begin to come out of the holes in the iron plate.
Note! Hold down the knob unl the self-cleaning funcon is complete.
9. Move the iron back and forth while steam and water are coming out of
it. Connue unl the water tank is basically empty.
10. Turn the steam control knob to the “0” posion (g. 1).
11. Connect the iron to a power source.
12. Set the temperature knob to the MAX posion. Let the iron heat up again.
The remaining water in the steam chamber will now evaporate and leave
the iron through the plate.
13. To clean the iron plate, it is recommended to iron a piece of old fabric.
CLEANING AND MAINTENANCE
• Aer the iron is unplugged and cooled down, simply wipe it with a damp
cloth, and if necessary, use a mild detergent.
• Never use harsh cleaning agents.
• Starch and other deposits can be easily removed from the iron plate by
wiping it with a damp cloth.
• To avoid scratching the nish, never use a metal sponge to clean the plate
and never place the iron on a rough surface.
• If you iron synthec fabrics at too high a temperature, there is a risk