SETTING THE OPERATION MODE
Setting the extraction operation mode
During the extraction mode, air is extracted to the outside with a special duct. Remove
the coal lters with this setting.
The cooker hood is connected to an opening that extracts the air to the outside with a stiff
or exible duct with the diameter of 150 or 120 mm and appropriate duct clamps which
are to be purchased in installation materials supply stores. The installation should be
performed by a qualied tter.
Setting the odor absorber operation mode
While using this mode, ltered air comes back to the room through openings on both
sides of the upper chimney. While using this mode, the coal lter should be installed, it is
also recommended to install an air exhaust n.
The speed of the fan
The lowest and medium speed settings are used in normal conditions and low cooking
fume intensity. The highest speed setting should be used only in case of an intense level
of cooking fumes e.g. during frying or grilling.
OPERATION
Control panel
The cooker hood can be controlled using
an integrated switch.
0 – motor off,
1 – rst operation speed,
2 – second operation speed,
3 – third operation speed,
– light on/off.
This adjustment allows to set the opti-
mal fan speed for the user’s needs with
a minimal noise level.
CLEANING AND MAINTENANCE
Maintenance
Regular cleaning and maintenance will guarantee a good and failure-free operation of
the cooker hood and will prolong its useful life. Make sure the aluminum lters and the
active-coal lters are replaced according to the manufacturer’s recommendations.
Anti-grease aluminum lters
1. Cleaning
In case of a normal operation of the cooker hood, the aluminum anti-grease lters
should be cleaned every two months in a dishwasher or manually with the use of a mild
detergent or liquid soap.
2. Replacement
To dismantle the lters:
a) Remove the lower cover by releasing the catch.
b) Take out the aluminum anti-grease lter.
To Next Page
Loading...