Be sure to install the batteries
provided with this remote. Match
positive (+) and negative (-) with
markings shown in battery com-
partment.
After installing batteries, the
remote resets to the following
brand codes:
TV = 100, CABLE = 300
Note: All VCR operations and menu
options can be accessed by using
the remote control.
A — Feature is not available.
ADJ (ADJUST Left/Right) — Adjusts tape play-
back tracking while in VCR mode. Use to change
status of TV menu options while in TV mode.
CH (Up/Down) — Changes favorite channels.
Also selects AUX A/V input channel.
CM SKIP — Fast forwards picture search through
30 seconds of recording.
EJECT — Ejects the tape in the VCR.
ENTER — Programs menu options and shows VCR
status display.
F FWD (Fast Forward)—Advances tape rapidly.
MEMORY — Returns real-time tape counter to
zero (M 0:00:00).
MENU — Shows main menu. Accesses Zenith TV
menus while in the TV mode.
MUTE — Press to turn off TV sound. Press again to
restore TV sound.
Numbers — Chooses channels and enters pro-
gramming information.
PAUSE — Pauses tape temporarily during playback
or record.
PLAY — Begins tape playback.
POWER — Turns VCR On and Off. Also turns VCR
Timer Off and On, if programmed.
PROGRAM — Programs remote with brand codes for
your brand of TV and/or cable box (DBS).
QUIT/CC — Exits menu system. Selects closed
caption for some TVs while in TV mode.
REC/ITR — Begins tape recording.
REW — Rewinds tape to the beginning.
SEL (SELECT Up/Down) — Chooses TV on-screen
menu options while in TV mode.
SP/EP — Chooses tape recording speed.
STOP — Cancels playback or record modes.
TV/VCR SOURCE — Switches source of TV picture
between TV channel and VCR channel selection.
VCR functions are available in TV mode.
VCR/CBL(DBS)/TV — Selects operational mode of
remote.
VOLUME (Up/Down) — Changes volume of TV.
Remote Control Operation
To Next Page
Loading...
