Need help?Do you have a question about the Zenith ZTSH Series and is the answer not in the manual?
General| Port Speed | 10/100/1000 Mbps |
|---|---|
| Switching Capacity | 48 Gbps |
| Forwarding Rate | 35.7 Mpps |
| MAC Address Table | 16K |
| Jumbo Frame Support | 9KB |
| Port Count | 24 |
Inspect equipment for transit damage, store in a clean, dry place with air circulation.
Use adequate lifting means, allow space for door opening and servicing, protect components during drilling.
Connect Normal, Emergency, and Load conductors to marked terminals, clean cables, and torque connections.
Connect engine start wires to control panel terminals and field connections for auxiliary contacts.
Remove debris, verify connections and phase rotation, check timers, verify torque, ensure covers are fastened.
Perform manual and electrical tests, check operation smoothly, verify voltages, and simulate power transfer.
Describes automatic transfer to Emergency and retransfer to Normal based on voltage and timers.
Provides a schematic diagram illustrating the transfer switch's electrical components and connections.
Lists and describes nine commonly specified accessories included in the Module 9 package.
Details various optional control accessories available to meet specific operational requirements.
Inspect and clean the switch to prevent dust, dirt, or moisture accumulation and check contact condition.
Replace worn parts with Zenith recommended parts and maintain lubrication of the operating mechanism.
Perform manual and electrical tests, including manual handle check and electrical transfer tests, to ensure proper operation.
Provides tables for diagnosing and correcting common issues like engine start/stop or transfer failures.
Describes adjustment of time units, ranges, and factory settings for solid state timers.
Explains adjustment of pickup voltage and frequency settings for the VFSM sensor.
Details the procedure for adjusting pickup and dropout points for the Solid State Phase Relay.
Provides instructions for programming the electronic time switch and its memory retention feature.
Explains setting time, day, programming, and installation for the Z2000-2A electronic time switch.
Recalls and reviews programmed ON/OFF times for the time switch.
Explains how to change or clear existing programs on the time switch.
Details how to manually change channel states temporarily, overriding automatic programming.
Describes how to continuously override automatic programming by pressing specific buttons.
Explains how to set up a holiday program override for a specified number of days.
Provides examples for programming engine start/stop times for different scenarios.
Lists part numbers and descriptions for components of the 40-260 Amp Power Panel.
Lists part numbers and descriptions for components of the 400 Amp Power Panel.
Lists part numbers and descriptions for components of the 600-1200 Amp Power Panel.
Lists part numbers and descriptions for components of the 1600-3000 Amp Power Panel.
Lists part numbers and descriptions for components of the 4000 Amp Power Panel.
Lists part numbers and descriptions for components of the Standard Control Panel (SSRCP).
Lists part numbers and descriptions for components of the Optional Control Panel.
To Next Page