T
teresa44Jul 26, 2025
What to do if bar and chain get hot and smoke on Zenoah G3200 Chainsaw?
- BBrenda VanceJul 26, 2025
If the bar and chain get hot and smoke during operation of your Zenoah Chainsaw, here are a few things to check: * Ensure the chain oil tank is full. Refill it every time you refill the fuel tank. * Check the chain tension. If it's too tight, adjust it. * Run the saw at full throttle for 15-30 seconds, then stop it and check if oil drips from the bar's tip. If there is no oil, contact an authorized service center.