Page 15 of 15
Troubleshooting
：
Issue Reason Solution
ePruner will not start Battery Depleted Charge Battery
Disconnected Battery Connect Battery
Power Switch Off Switch On
Power Switch Failure Notify Dealer
Runs abnormal Connector Damaged
Notify Dealer
Trigger Switch Damaged
Blade super hot Blade Dull Sharpen Blade or Replace
Blade Damaged Sharpen Blade or Replace
Lubrication Low Apply Grease to Blade
Cutting surface bad Friction Force added Apply Grease to Blade
Dirt on Blade Clean Blade
Blade Dull sharpen blade or replace
artifice not enough Read Instructions carefully
Battery Depleted Charge battery
Red LED flash on charger Battery not fully charged
or fully inserted in charger
Charge or re-insert the
battery to charger
Charger not connected to
power
Re-connect
Electrode dirty Clean dirt
Battery failure Replace battery
Charger failure Replace charger
Two warning notes / two
warning notes repeat
10 times
Signal for blade opening
failure, shear is in need of
repair
Notify Dealer
Three warning notes / two
warning notes repeats 10
times
signal for cutting closing
positioning fail, shear is in
need of repair
Notify Dealer
Four warning notes/ two
warning notes repeats 10
times
motor failure, shear is in
need of repair
Notify Dealer
Ten warning notes/ two
warning notes repeats 10
times
Minor maintenance needed Add grease to worm drive
Five long warning notes /
repeats 10 times
Major maintenance needed Notify Dealer
To Previous Page
Loading...
Need help?
General
