Why is the filter vibrating in my Zephyr Ventilation Hood?
If the filter in your Zephyr Ventilation Hood is vibrating, adjust or change the filter. If the spring clip on the filter is broken, change the spring clip.
Why is my Zephyr AK9334BS Ventilation Hood not venting properly?
Several factors can cause this. Ensure you're using the correct size ducting. The distance between the cooktop and the hood's bottom should be between 24 and 36 inches. Close any nearby windows and doors to prevent wind interference. Finally, check for and remove any blockages in the ductwork or duct opening. Change the ducting to the correct size. Adjust the distance between the cook top and the bottom of the hood within 24” and 36” range. Close all the windows and doors to eliminate the outside wind flow. Remove all the blocking from the duct work or duct opening.
Essential safety precautions for operation, installation, and fire prevention.
Specifies voltage, circuit, wiring standards, and grounding for safe electrical installation.
Details power requirements, wiring standards, and safety precautions for electrical hookup.
Step-by-step guide for preparing the unit and performing the physical installation.
General| Color | stainless steel |
|---|---|
| Hood Type | insert |
| Venting Type | ducted, external |
| Temperature Sensor | no |
| Control Type | button |
| Delay Start | yes |
| Interior Light | yes |
| Remote Control | no |
| Voltage | 120 volts |
Weight and Dimensions| Depth | 22 1/2 inches |
|---|---|
| Height | 12 inches |
| Width | 34 3/8 inches |
| Net Weight | 53.6 pounds |
To Next Page