Why is the filter vibrating in my Zephyr AK9346BS Ventilation Hood?
If the filter in your Zephyr Ventilation Hood is vibrating, adjust or change the filter. If the spring clip on the filter is broken, change the spring clip.
Why is my Zephyr AK9346BS Ventilation Hood not venting properly?
Several factors can cause this. Ensure you're using the correct size ducting. The distance between the cooktop and the hood's bottom should be between 24 and 36 inches. Close any nearby windows and doors to prevent wind interference. Finally, check for and remove any blockages in the ductwork or duct opening. Change the ducting to the correct size. Adjust the distance between the cook top and the bottom of the hood within 24” and 36” range. Close all the windows and doors to eliminate the outside wind flow. Remove all the blocking from the duct work or duct opening.
Lists general safety warnings and precautions for operating the appliance.
Provides crucial warnings and instructions for preventing and handling range top grease fires.
Details safety requirements for installation work and proper ductwork usage.
Covers safe operation practices and essential electrical installation requirements.
Specifies optimal mounting dimensions and clearance requirements for the hood.
Outlines the initial steps for preparing and physically installing the hood unit.
Steps for enabling ACT™ and methods to verify its configuration and blower speed.
Presents the electrical circuit diagram and associated ACT™ CFM ratings.
Addresses common problems like the unit not powering on or the blower not turning.
General| Color | stainless steel |
|---|---|
| Hood Type | insert |
| Venting Type | ducted, external |
| Temperature Sensor | no |
| Control Type | button |
| Delay Start | yes |
| Interior Light | yes |
| Remote Control | no |
| Voltage | 120 volts |
Weight and Dimensions| Depth | 22 1/2 inches |
|---|---|
| Height | 12 inches |
| Width | 46 3/8 inches |
| Net Weight | 64.9 pounds |
To Next Page