INSTALLATION
5
MOUNTING THE RANGEHOOD
1.This range hood is mounted under a
kitchen cabinet unit.
2. Select preferred duct location on rear or
top of unit. For ductless conversion, no
ducting is required.
3.An optional spacer plate is provided to
cover the gap between the back of the
hood and the wall. If using this plate,
screw it onto the hood prior to installation.
4. Begin installation by temporarily removing
the filter panels.
5.Temporarily position the range hood in
the desired mounting location.
6. Mark the mounting holes, duct and
electrical access locations with a pencil.
For ductless conversion,no hole is required
for a duct.
7.Drill/cut out the required openings for duct
and electrical access.
8.Install duct work and electrical.
To Next Page
Loading...
