Flash Storage Capability
The Zepp sensor is capable of working both when connected to the app
(online mode) and when the app is not connected. (offline mode) For
Zepp Baseball, it is recommended to operate in online mode (connected
to app). In online mode the Zepp sensor is used when your connected to
the app on your phone or tablet. All swings are stored immediately and
saved to the app. If you lose connection or capture swings in offline mode
all of your swings will be stored locally on the sensor until you reconnect
to the app again.
Battery Life, Charging and Power
Battery Life
It is recommended to fully charge the sensor prior to use. This may take
up to 2-3 hours. The battery will last up to 5.5 hours with continuous
swing recording.
Charging
Place your sensor into the USB Charger included in the box, and plug the
charger into any USB port. Charging your sensor will take approximately
2-3 hours. When charging is complete the light rotation of the sensor will
show all 10 of the LED lights will light up for a moment followed by all 10
LED lights fading away. This cycle repeating while in the charger
indicating a full charge.
Hibernate Mode
To save battery the sensor will enter a Hibernation Mode if it does not
detect a swing or a button press for 5 minutes. Simply press the multi-
function button or take a swing to wake the sensor out of hibernation
mode. If you find that the sensor disconnects from the app during this
time, press the multi-function button twice to reconnect to the app.
Firmware Updates
Zepp will periodically include firmware updates when updates to the app
are released. Updating the firmware will improve accuracy and overall
performance of the sensor. To check if a firmware update is available,
sync the sensor to the app. !If an update is available you'll see a red (1)
hovering over the Settings icon as shown below. Enter the settings and
select firmware update and follow the steps listed in the app. If firmware
update does not appear in your settings, then your sensors firmware is up
to date. This update will not take more than a few minutes to complete.
To Next Page
Loading...