Turning on the Zepp Sensor
To turn it on, press in from the side towards the LED channel (see image
below). You should feel the button push in slightly when you do this. Hold
for at least 4 seconds when pushed in. If it doesn't turn on try holding a
bit longer and adjusting your finger to the top corner.
Pairing the Zepp Sensor
Pairing an iOS Device
1. Select the Settings icon and then select Bluetooth.! If Bluetooth is not
enabled, turn it on.
2. Your iOS device will automatically search for Zepp. This may take up to
15-30 seconds.! Once found, a pop up "Bluetooth Pairing Request" will
appear. !Select Pair.
3. When paired, your device will note Zepp “Connected”.
4. After connection has been established, another pop up will appear
asking you to allow Zepp to communicate with the Zepp App. !Select
Allow.
5. From this point on, your iOS device will automatically pair with Zepp
Baseball. !Unless if you turn Bluetooth off or unconnected Zepp by
selecting “Forget this Device”, you will not need to pair the device when
you turn on your Zepp.
To Next Page
Loading...