Controls and Components
3.20
E. Motor Stop Switch
When the top of the switch (A) is pressed, it cuts off power
to the motor controller. The motor controller remains in this
state until the bottom portion of the switch (B) is pressed.
The switch does not turn off all electrical circuits, just the
operation of the motor.
F. Performance Level Mode Button
See “Performance Level Mode Button”, on page 3.21.
G. Hazard Warning Flasher Switch
When the top of the switch is pressed, the turn signals flash
to warn other drivers of situations, which include needing to
stop or park under emergency conditions. When the bottom
of the switch is pressed, the hazard warning circuit will turn
off.
H. Turn Signal Switch
When the turn signal switch is pushed in the
left or right position, the corresponding front
and rear turn signals flash. When the turn
signal switch is ON, the corresponding turn signal indicator
on the lower dash illuminates.
Always signal your turns and other maneuvers as required
by law. Unlike an automobile, the turn signals must always
be canceled manually on the motorcycle. Push in on the
switch and it returns to the center, or OFF position.
I. Horn Button
When the key is in the ON position, the horn (A) sounds
when the button is pressed. Electric vehicles run quietly;
the horn can be used to warn pedestrians or other motorists
of your presence.
Zero Owner's Manual (FX and FXS).book Page 20 Thursday, May 13, 2021 10:53 AM
To Next Page
Loading...
