Controls and Components
3.13
Dash Settings
The displays on the dash can be customized to your personal
preferences by using the ADJ (Adjust) and SEL (Select) buttons.
A. Select Button (SEL)
By momentarily pressing or holding the SEL button you can
reset or select fields in Display A and Display B, change the
time, and change the display units.
B. Adjust Button (ADJ)
By momentarily pressing or holding the ADJ button you can
reset fields and toggle through the trip menus and display
options.
Note: Once a feature is selected, it will stop flashing after 15
seconds if no further button press is detected, and the dash will
return to its normal operating mode.
Display A
To select Display A with the dash in its normal operating mode,
momentarily press the SEL button once. Press the ADJ button
to toggle through the following fields:
• RANGE - Displays the estimated range based on learned
riding style and usage.
• MOTOR - Displays motor RPM.
• TRIP 1 - Displays individual trip mileage and is reset by
pressing and holding the ADJ button for 2 seconds.
Note: Trip 1 is reset each time the battery is recharged to
100%.
• ERROR - Displays 2-digit diagnostic code. See “Diagnostic
Codes”, on page 7.5
Zero Owner's Manual (FX and FXS).book Page 13 Thursday, May 13, 2021 10:53 AM
To Next Page
Loading...
