Power Pack and Charging
5.10
7. The green charge LED on the dash will begin blinking
steadily to indicate charge flow. If the key switch was turned
to the ON position, now turn it to the OFF position.
8. When the green charge LED becomes solid or the SOC reads
100%, the battery system is fully charged, disconnect the
charger. When the power pack is fully charged, disconnect
the chargers and reinstall the protective cover.
Note: If Quick Charger will be used again, cut access flap (see
dashed line (B)) in flexible protective cover before re-installation.
Do not cut across the top of the flap. Do not completely remove
flap.
Zero Owner's Manual (FX and FXS).book Page 10 Thursday, May 13, 2021 10:53 AM
To Next Page
Loading...
