Revision Date – 15/07/2020 page 8
5 TOOLS REQUIRED
5.1 Basic servicing
The following tools will be required to perform general non-refrigeration based servicing of the fridge.
Basic tool kit
Phillips head screw drivers (various sizes)
Flat blade screw drivers (various sizes)
Needle nosed plies
Wire (side) cutters
Vice grips
Sharp knife
Allen key set
Cable ties
12V power supply
Multimeter (with the following ranges)
DC voltage (0 - 24V)
AC voltage (100 - 240V)
Resistance (0.5 Ω – 50 kΩ)
Temperature +10°C (+50°F) to -18°C (0°F)
Jumper cable
Short length of insulated wire terminated with spring loaded clips or push-on
connectors at each end.
The following tools will be required to perform specific non-refrigeration based servicing of the fridge
Check vehicle wiring (refer to section 8.1)
DC Voltage Drop tester (available from ARB – part # 10910040)
Replace serviceable thermistor (refer to section 9.10)
Heat transfer paste (available from Jaycar p/n NM-2012)
5.2 Servicing the refrigeration system
It is expected that a refrigeration mechanic who is servicing the refrigeration system will have the
appropriate equipment to pressure test, evacuate and charge the system with the specified refrigerant in
accordance with local or State handling practices.
To Next Page
Loading...
Need help?
General