Need help?Do you have a question about the Zero PORTA and is the answer not in the manual?
General| Brand | Zero |
|---|---|
| Model | PORTA |
| Category | Control Unit |
| Language | English |
General safety guidelines for installation and use to prevent injury and damage.
Details the function of each pin on CN1 and CN2 connectors for wiring.
Notes for understanding control board functions before configuration.
Lists power supply, motor output, working temperature, radio receiver, and memory capacity.
Explains DIP switch settings for automatic closing, operation time, and programming.
Details how to enable or disable radio programming of new transmitters.
Describes the 'dead man' mode where the button must be held for operation.
Configuration of photocells and safety edges using DIP switches.
Instructions for storing transmitter codes when the control panel is stable.
Step-by-step guide for storing transmitter codes using the PROG button.
Procedure to reset the memory and erase all stored transmitter codes.
Method for programming remote controls using a hidden button on existing transmitters.
How to program the automatic closing timer duration using a start button or transmitter.
How to program the operating time and automatic stop limits for the motor.
Troubleshooting steps when the door opens but fails to close.
Steps to diagnose motor issues, checking power supply and fuses.
To Next Page