Glossary JesterML Operating Manual
73-406-00 Issue 3.0 71 of 85
Green
The colour of the PROGRAM/GO button when the desk is in RUN mode.
Help
To obtain the Online Help for the JesterML, press SHIFT, LEFT and RIGHT at the
same time. The language can be changed in Setup.
HTP
Highest Takes Precedence. The mixing method used for brightness channels, where
activating one source on top of another will result in additive mixing.
Home Button
This button sets all channels of the selected fixtures to their default values, as
defined in the fixture profile information. It can be used in conjunction with the
FIXTURES, COLOUR, BEAMSHAPE and POSITION buttons to set only the chosen
attributes to their default values. In Partial Mode, this tags the homed parameters.
IEC320-C14
The type of mains input connector on the inline PSU, sometimes shortened to simply
IEC, or referred to as a kettle plug.
.IFT
The file extension used by Zero 88 for fixture profile information. The format of the
data is not published, and is only compatible with PC applications supplied by Zero
88.
Insert Button
The button on the JesterML which is used to add a memory between two scenes, or
to add another step to a chase.
Intensity
How bright a light is. Also known as Brightness or Dimmer. On the JesterML,
fixture intensities are controlled by the wheels when FIXTURES is selected.
Inverse Channel
A fixture channel which has ‘Invert Output’ set in it’s Fixture Profile will output the
inverse value of what is programmed in the desk. This is useful for certain fixtures
where the dimmer channel is full at DMX value 0 and off at DMX value 255.
Isolated
The DMX512-A input port on the back of the JesterML is opto-isolated. Conversely,
the DMX512-A output port on the back of the JesterML is not isolated. This is the
preferred grounding topology of the DMX512-A standard.
Jack
The connector used for the Audio In and Remote connectors on the JesterML. The
Jack used is the ¼ inch, stereo variety.
To Next Page
Loading...
Need help?
General