ZEUS-200S/150 ZO-OM-007
REV : 08 18 ZERONE
③ Coagulation Mode
ⓐ Contact Coagulation
Select this button for the coagulation with the minimized level of arrest of bleeding.
If it is selected, the lamp next to the button turns on.
ⓑ Spray Coagulation
Select this button for the coagulation with the maximized level of arrest of bleeding.
If it is selected, the lamp next to the button turns on.
ⓒ Bipolar Coagulation
Bipolar hemostasis using Foot Switch.
If it is selected, the lamp next to the button turns on.
ⓓ Coagulation Output Set-Up Indicator
Coagulation and bipolar coagulation output is displayed in W.
ⓔ Coagulation Output Confirmation Lamp
When a selected coagulation mode is operated, the lamp turns on.
ⓕ Coagulation Output Increase
This button increases the output of selected mode. When this button is pressed
one time, the output get raised by 1Watt. Continuously-pressing leads the output
to its highest level.
ⓖ Coagulation Output Decrease
This button decreases the output of selected mode. When this button is pressed
one time, the output get reduced by 1Watt. Continuously-pressing leads the output
to its lowest level.
When the LED and the display shows Cutting/Coagulation Mode you have
chosen in Auto Mode, the power output Up/Down (Increase/Decrease) button
does not work. Select the mode, and then use the Up/Down button to
increase/decrease
the power output.
To Next Page
Loading...
