Zeta ID2/2 - Design Certificate

INFINITY ID2 USER MANUAL, MAINTENANCE GUIDE & LOG BOOK Software Versions: PANEL 0.X – R8629 & LOOP 0.J-R624
Approved Document No: GLT2-211-7-2 PAGE 22
Issue 1.00 Author: NRPJ Date: 23/1/2013
Design Certificate (Page 1 of 2)
Certificate of DESIGN for the Infinity ID2 Fire Alarm System installed at:
ADDRESS:
I/we being the competent person(s) responsible (as indicated by my/our signatures below) for the design of
the fire alarm system, particulars of which are set out below, CERTIFY that the said design for which I/we
have been responsible complies to the best of my/our knowledge and belief with the recommendations of
section 2 of BS 5839-1:2002 for the system category described below, except for the variations, if any,
stated in this certificate
Name (Block Letters):
Position:
Signature:
Date:
For & on behalf of:
Address
The extent of liability of the signatory is limited to the system described below.
System Category (see BS 5839-1:2002, Clause 5):
Variations from the recommendations of section 2 of BS 5839-1:2002 (see Clause 7):)
Extent of system covered by this certificate:
Brief description of areas protected (not applicable for Category M, L1 or P1 systems):